 |
 |
 |
Turning: |
You have turned the cylinder and are left with a lot of burrs at the ends
which will affect efficiency and your customer doesn't like how it looks;
Take Set B or E for external deburring of holes, tubes and slots from 1.5 mm.
|
|
 |
|
Milling: |
You have milled a corner of a workpiece and are are left with a radius in
that corner.
You need Set G3 which cleans corners of slots and unwanted radii.
|
|
 |
|
Milling: |
A slot has been milled and there are burrs on both sides.
Set G will solve your problem.
|
|
 |
|
Sawing: |
When you saw or cut material burrs are always left.
Problem is solved with our Sets B or E.
Just run the blade across the material - No burrs !
|
|
 |
|
Cutting: |
After cutting a tube, burrs are left both inside and outside.
Sets B/E/C solve the internal problem.
Set Burr-Ex solves the external problem.
|
|
 |
|
Drilling: |
You have drilled a hole and burrs are everywhere.
You need Set B or Set E to remove the internal burrs in one pass.
|
|
 |
|
Wood: |
Problems with a wooden frame ?
Set B the rotational deburring workhorse or Set E will take off the edge
and leave the surface smooth and ready for painting.
|
|
No matter where your burrs are SHAVIV by Vargus has the answer.
Just let us know the problem and we'll provide the solution.
|
